The Full Wiki

More info on Effective radiated power

Effective radiated power: Map


Wikipedia article:

Map showing all locations mentioned on Wikipedia article:

In radio telecommunications, effective radiated power or equivalent radiated power (ERP) is a standardized theoretical measurement of radio frequency (RF) energy using the SI unit watts, and is determined by subtracting system losses and adding system gain. ERP takes into consideration transmitter power output (TPO), transmission line attenuation (electrical resistance and RF radiation), RF connector insertion losses, and antenna directivity, but not height above average terrain (HAAT). ERP is typically applied to antenna systems.

For a simplified example, if an antenna system has 9 dB gain and 6 dB loss, its ERP is 3 dB over (equal to double) the TPO. The use of circular polarization, or otherwise splitting between horizontal and vertical linear polarization, causes a "loss" of 3dB, cutting the reported ERP in half. If full-wavelength spacing is used between antenna elements in an array, the ERP is increased multiplicative with the number of elements. For half-wave-spaced elements (used to limit RF radiation hazard beneath the radio tower), only half of the elements count. Null fill also detracts from the ERP by increasing the power in the nulls that form between side lobes. Stations with beam tilt often have two ERPs listed: one at the angle of tilt (the main lobe), and another in the standard horizontal plane. When only one ERP is listed, this is usually referring to the power in the main lobe.

FM example

For example, an FM radio station which advertises that it has 100,000 watts of power actually has 100,000 watts ERP, and probably not an actual 100,000-watt transmitter. The TPO of such a station typically may be 10,000 to 20,000 watts, with a gain factor of 5 to 10 (5× to 10×, or 7 to 10dB). In most antenna designs, gain is realized primarily by concentrating power toward the horizontal plane and suppressing it at upward and downward angles, through the use of phased arrays of antenna elements. The distribution of power versus elevation angle is known as the vertical pattern. When an antenna is also directional horizontally, gain and ERP will vary with azimuth (compass direction). Rather than the average, it is the maximum ERP in any direction that is usually quoted as a station's power. This is particularly applicable to the huge ERPs reported for shortwave broadcasting stations, which use very narrow beam widths to get their signals across continents and oceans.

United States regulatory usage

ERP for FM radio in the United States is always relative to a theoretical reference half-wave dipole antenna. To deal with antenna polarization, the Federal Communications Commission (FCC) lists ERP in both the horizontal and vertical measurements for FM and TV. Horizontal is the standard for both, but if the vertical ERP is larger it will be used instead.

The maximum ERP for US FM broadcasting is usually 100,000 watts (FM zone II) or 50,000 watts (the more densely populated FM zones I/I-A), though exact restrictions vary depending on the class of license. Some stations have been grandfathered in or, very infrequently, been given a waiver, and can exceed normal restrictions.

Microwave band issues

For most microwave systems, a completely non-directional isotropic antenna (one which radiates equally and perfectly well in every direction – a physical impossibility) is used as a reference antenna. This includes satellite transponders, radar, and other systems which use microwave dishes and reflectors rather than dipole-style antennas.

Lower-frequency issues

In the case of mediumwave (AM) stations in the United Statesmarker, actual radiated power is used for an omnidirectional station; for a directional station, power is computed relative to an omnidirectional radiator with the same nominal power and an efficiency equal either to the RMS efficiency of the directional antenna under consideration, or to the minimum efficiency permitted for the class of station.

Related terms

  • Effective monopole radiated power (EMRP) may be used in Europe, especially in relation to mediumwave broadcasting antennas. This is the same as ERP, except that a short vertical antenna (i.e. a short monopole) is used as the reference antenna instead of a half-wave dipole.


The height above average terrain for VHF and higher frequencies is extremely important when considering ERP, as the signal coverage (broadcast range) produced by a given ERP dramatically increases with antenna height. Because of this, it is possible for a station of only a few hundred watts ERP to cover more area than one of a few thousand, as its signal travels above obstructions on the ground.

See also


  1. {{cite web | title = Recommendation ITU-R M.1224 | publisher = International Telecommunication Union | url ={366E7A63-5216-404F-B7F9-EAFA78CB464D} | accessdate = 2008-08-29 }}

Embed code:

Got something to say? Make a comment.
Your name
Your email address