The Full Wiki

Intel 8088: Map


Wikipedia article:

Map showing all locations mentioned on Wikipedia article:

The Intel 8088 microprocessor was a variant of the Intel 8086 and was introduced on July 1, 1979. It had an 8-bit external data bus instead of the 16-bit bus of the 8086. The 16-bit registers and the one megabyte address range were unchanged, however. The original IBM PC was based on the 8088.

History and description

The 8088 was targeted at economical systems by allowing the use of an 8-bit data path and 8-bit support and peripheral chips; complex circuit boards were still fairly cumbersome and expensive when it was released. The prefetch queue of the 8088 was shortened to four bytes, from the 8086's six bytes, and the prefetch algorithm was slightly modified to adapt to the narrower bus. These modifications of the basic 8086 design were one of the first jobs assigned to Intel's then new design office and laboratory in Haifamarker Israelmarker.

The Intel 80C88.
Variants of the 8088 with more than 5 MHz maximum clock frequency include the 8088-2, which was fabricated using Intel's new enhanced nMOS process called HMOS and specified for a maximum frequency of 8 MHz. Later followed the 80C88, a fully static CHMOS design, which could operate from DC to 8 MHz. There were also several other, more or less similar, variants from other manufacturers. For instance, the NEC V20 was a pin compatible and slightly faster (at the same clock frequency) variant of the 8088, designed and manufactured by NEC. Successive NEC 8088 compatible processors would run at up to 16 MHz.


Depending on the clock frequency, the number of memory wait states, as well as on the characteristics of the particular application program, the average performance for the Intel 8088 ranged from approximately 0.33 to 1 million instructions per second [2033]. Meanwhile, the mov and ALU reg,reg instructions taking 2 and 3 cycles respectively yielded an absolute peak performance of between 1/3 and 1/2 MIPS per MHz, that is, somewhere in the range 3–5 MIPS at 10 MHz.

Selection for use in the IBM PC

The original IBM PC was the most influential microcomputer to use the 8088. It used a clock frequency of 4.77 MHz (4/3 the NTSC colorburst frequency). Some of IBM's engineers and other employees wanted to use the IBM 801 processor, some preferred the new Motorola 68000, while others argued for a small and simple microprocessor similar to what had been used in earlier personal computers. However, IBM already had a history of using Intel chips in its products and had also acquired the rights to manufacture the 8086 family. Another factor was that the 8088 allowed the computer to be based on a modified 8085 design, as it could easily interface with existing, and quite economical, 8085-type components.

The descendants of the 8088 include the 80188, 80186, 80286, 80386, and later software compatible processors, which are in use today. See below for a more complete list.

See also

External links

Intel Datasheet

Notes and references

  1. ALU stands for one of the instructions add,adc,sub,sbc,cmp,and,or,xor.
  2. Later used for the IBM Instruments 9000 Laboratory Computer
  3. There were some rumours that (the then small) Microsoft somehow managed to persuade IBM to use the 8088, because it had more and better 16-bit capabilities than most other "8-bit" CPUs.
  4. In exchange for giving Intel the rights to its bubble memory designs. However, due to fierce competition from Japanese manufacturers who were able to undercut by cost, Intel soon left this market and changed focus to microprocessors
  5. 68000 components were not widely available at the time, though it could use Motorola 6800 components to an extent.

Embed code:

Got something to say? Make a comment.
Your name
Your email address